Skip to content
FiftyCalc Free calculators for all 50 states

Hammock Hang Calculator

Test cases replayed : 2 of 2 match · Methodology · No outside source listed

Enter the load in the hammock and the angle each suspension line makes with the horizontal to see the force on each strap.

Result

Sample figures

Tension in each strap (lbf)—

Sideways pull on each anchor (lbf) —

  • Downward load on each anchor (lbf)—
  • Strap tension as a multiple of the load—

The unit choice applies to the fields you fill in. Results stay in the units written with them.

Estimate for planning only, not tax, legal, financial or medical advice. This calculator uses the method explained on this page.

Hammock Hang Calculator

Units: switches the fields between the two unit systems.

Load in the hammock (person plus gear), in lb: enter 0 or more. Prefilled example: 200.

Hang angle of each strap above horizontal, in °: enter a number from 1 to 89. Prefilled example: 30.

Affiliate link

This is an affiliate link. As an Amazon Associate I earn from qualifying purchases. This does not change the result.

Search Amazon for hammock tree straps. Visit Amazon

How to use this calculator

Fill in the fields in this order; each step takes you to its field.

  1. Units: switches the fields between the two unit systems.
  2. Load in the hammock (person plus gear), in lb: enter 0 or more.
  3. Hang angle of each strap above horizontal, in °: enter a number from 1 to 89.
  4. Read the result: Tension in each strap (lbf); the panel also shows Sideways pull on each anchor (lbf), Downward load on each anchor (lbf) and Strap tension as a multiple of the load.

How this calculator works

A hammock hung between two anchors is a two-point suspension. With the load W at the middle and both lines at angle θ above the horizontal, vertical balance gives 2 × T × sin θ = W, so the tension in each line is T = W ÷ (2 sin θ).

Each anchor carries the vertical part W ÷ 2 and a sideways pull T × cos θ. At 30° the tension equals the full load; flatter hangs raise it quickly (at 10° it is about 2.9 times the load), which is why a 30° hang is the usual recommendation.

This is static equilibrium only: bouncing or dropping into the hammock adds dynamic load, so straps and anchors need a working margin above the figure shown.

The formula

  1. T=W2×sin⁡(rad⁡(a))
Symbols used in the formula
SymbolMeaningUnit
WLoad in the hammock (person plus gear)lb
aHang angle of each strap above horizontal°
TTension in each straplbf
rad(x)the angle x, converted from degrees to radians.

Worked example

Load in the hammock (person plus gear)200 lb
Hang angle of each strap above horizontal30 °
Sideways pull on each anchor (lbf)173.2051
Downward load on each anchor (lbf)100
Strap tension as a multiple of the load1
  1. T=2002×sin⁡(rad⁡(30))=200

Tension in each strap (lbf) 200

Each step uses the unrounded value of the step before it; figures on this page are rounded for display.

Frequently asked questions

Why hang a hammock at 30 degrees?

Because sin 30° = 0.5, each strap then carries exactly the load in the hammock, for example 200 lbf for a 200 lb load. A flatter hang multiplies the force.

How much force is on each strap at 10 degrees?

About 2.88 times the load: 576 lbf for a 200 lb load, from 200 ÷ (2 × sin 10°).

Questions answered

Related calculators