Elongation Calculator
Test cases replayed : 2 of 2 match · Methodology · No outside source listed
Enter the original gauge length and the gauge length measured after the test (or under load), in the same unit.
Result
Percent elongation
Change in length (same unit)
- Engineering strain (unitless)
Estimate for planning only, not tax, legal, financial or medical advice. This calculator uses the method explained on this page.
This browser did not allow copying. The sentence is in the box below, already selected: copy it with your keyboard or the menu.
How to use this calculator
Fill in the fields in this order; each step takes you to its field.
- Original gauge length: enter 0 or more.
- Final gauge length (same unit): enter a number.
- Read the result: Percent elongation; the panel also shows Change in length (same unit) and Engineering strain (unitless).
How this calculator works
Percent elongation = (L_f − L₀) ÷ L₀ × 100, with L₀ the original gauge length and L_f the final gauge length. Engineering strain is the same ratio without the 100.
For a tensile test result the two broken halves are fitted together and the gauge marks are measured again, as tensile test standards describe; report the gauge length with the result, because elongation depends on it.
The formula
| Symbol | Meaning | Unit |
|---|---|---|
| Original gauge length | ||
| Final gauge length | same unit | |
| Percent elongation | % |
Worked example
| Original gauge length | 50 |
|---|---|
| Final gauge length (same unit) | 62 |
| Change in length (same unit) | 12 |
|---|---|
| Engineering strain (unitless) | 0.24 |
Percent elongation 24%
Each step uses the unrounded value of the step before it; figures on this page are rounded for display.
Frequently asked questions
A 50 mm gauge length measures 62 mm after fracture. What is the elongation?
24% (12 ÷ 50 × 100), an engineering strain of 0.24.
Does the unit matter?
No, as long as both lengths use the same unit; the ratio has no unit.