Skip to content
FiftyCalc Free calculators for all 50 states

True Strain Calculator

Test cases replayed : 2 of 2 match · Methodology · No outside source listed

Enter the original and current gauge length (and the engineering stress if you have it) to get true strain and true stress.

Result

Sample figures

True strain—

Engineering strain —

  • True stress (same unit as the stress entered)—

Estimate for planning only, not tax, legal, financial or medical advice. This calculator uses the method explained on this page.

True Strain Calculator

Original gauge length (any unit): enter 0 or more. Prefilled example: 50.

Current length (same unit): enter 0 or more. Prefilled example: 55.

Engineering stress (MPa, psi or any unit): enter a number. Prefilled example: 400.

How to use this calculator

Fill in the fields in this order; each step takes you to its field.

  1. Original gauge length (any unit): enter 0 or more.
  2. Current length (same unit): enter 0 or more.
  3. Engineering stress (MPa, psi or any unit): enter a number.
  4. Read the result: True strain; the panel also shows Engineering strain and True stress (same unit as the stress entered).

How this calculator works

True (logarithmic) strain is ε_t = ln(L / L₀) = ln(1 + ε), where ε = (L − L₀) / L₀ is the engineering strain.

True stress σ_t = σ (1 + ε), from constant volume during plastic flow (A · L = A₀ · L₀). Both relations hold for uniform deformation, up to the start of necking in a tensile test (ASTM E8 test geometry).

The formula

  1. Et=ln⁡(ll0)
Symbols used in the formula
SymbolMeaningUnit
l0Original gauge lengthany unit
lCurrent lengthsame unit
EtTrue strain

Worked example

Original gauge length (any unit)50
Current length (same unit)55
Engineering stress (MPa, psi or any unit)400
Engineering strain0.1
True stress (same unit as the stress entered)440
  1. Et=ln⁡(5550)=0.0953102

True strain 0.0953

Each step uses the unrounded value of the step before it; figures on this page are rounded for display.

Frequently asked questions

Why is true strain smaller than engineering strain in tension?

True strain adds up each small stretch relative to the current length, which keeps growing, so ln(1 + ε) is always a little less than ε.

Can I add true strains?

Yes. True strains of successive steps add up, which engineering strains do not.

Questions answered

Related calculators