Skip to content
FiftyCalc Free calculators for all 50 states

Vickers Hardness Calculator

Test cases replayed : 2 of 2 match · Methodology · No outside source listed

Enter the test force and the two diagonals of the square indentation to get the Vickers hardness number.

Result

Sample figures

Vickers hardness (HV)—

Mean diagonal (mm) —

Estimate for planning only, not tax, legal, financial or medical advice. This calculator uses the method explained on this page.

Vickers Hardness Calculator

Force unit

Force unit: choose kilogram-force (kgf) or newtons (N). Prefilled example: kilogram-force (kgf).

Test force: enter 0 or more. Prefilled example: 10.

Diagonal d₁, in mm: enter 0 or more. Prefilled example: 0.42.

Diagonal d₂, in mm: enter 0 or more. Prefilled example: 0.44.

How to use this calculator

Fill in the fields in this order; each step takes you to its field.

  1. Force unit: choose kilogram-force (kgf) or newtons (N).
  2. Test force: enter 0 or more.
  3. Diagonal d₁, in mm: enter 0 or more.
  4. Diagonal d₂, in mm: enter 0 or more.
  5. Read the result: Vickers hardness (HV); the panel also shows Mean diagonal (mm).

How this calculator works

The Vickers test (ISO 6507-1, ASTM E92) presses a square-based diamond pyramid with a 136° angle between opposite faces into the material. HV = 2 F sin(136°/2) / d² = 1.8544 F / d², with F in kgf and d the mean of the two diagonals in mm.

With the force in newtons, F is first divided by 9.80665 N/kgf (NIST SP 811, Appendix B, read October 27, 2026), which gives HV = 0.1891 F / d².

Results are written with the load, for example 100 HV10 for a 10 kgf test.

The formula

  1. D=d1+d22
  2. Hv=2×sin⁡(rad⁡(68))×{f9.80665if fu=2fotherwiseD2
Symbols used in the formula
SymbolMeaningUnit
fuForce unit (1: kilogram-force (kgf); 2: newtons (N))
fTest force
d1Diagonal d₁mm
d2Diagonal d₂mm
DMean diagonalmm
HvVickers hardness (HV)
rad(x)the angle x, converted from degrees to radians.

Worked example

Force unitkilogram-force (kgf)
Test force10
Diagonal d₁0.42 mm
Diagonal d₂0.44 mm
Mean diagonal (mm)0.43
  1. D=0.42+0.442=0.43
  2. Hv=2×sin⁡(rad⁡(68))×100.432=100.29

Vickers hardness (HV) 100.3

Each step uses the unrounded value of the step before it; figures on this page are rounded for display.

Frequently asked questions

Why measure two diagonals?

The indentation is rarely a perfect square; the standard uses the mean of both diagonals.

Does the load change the hardness value?

In principle Vickers hardness is nearly independent of load, but very light (micro) loads can give higher values, so the load is always stated.

Questions answered

Related calculators