Skip to content
FiftyCalc Free calculators for all 50 states

Angle Cut Calculator

Test cases replayed : 2 of 2 match · Methodology · No outside source listed

Enter the board width and the cut angle measured from a square cut, as set on a miter saw.

Result

Sample figures

Offset along the board edge—in

Length of the cut face (inches) —

  • Angle between the cut and the board edge (degrees)—

The unit choice applies to the fields you fill in. Results stay in the units written with them.

Estimate for planning only, not tax, legal, financial or medical advice. This calculator uses the method explained on this page.

Angle Cut Calculator

Units: switches the fields between the two unit systems.

Board width across the cut, in in: enter 0 or more. Prefilled example: 5.5.

Cut angle from square, in °: enter a number from 0 to 89. Prefilled example: 45.

How to use this calculator

Fill in the fields in this order; each step takes you to its field.

  1. Units: switches the fields between the two unit systems.
  2. Board width across the cut, in in: enter 0 or more.
  3. Cut angle from square, in °: enter a number from 0 to 89.
  4. Read the result: Offset along the board edge; the panel also shows Length of the cut face (inches) and Angle between the cut and the board edge (degrees).

How this calculator works

A cut at angle θ from square across a board of width w runs w × tan θ along the edge (the difference between the long and short points), and the cut face is w ÷ cos θ long.

Miter saws read the angle from square (0° = square cut), which is the angle used here; the angle between the cut line and the board edge is 90° − θ.

The formula

  1. O=w×tan⁡(rad⁡(a))
Symbols used in the formula
SymbolMeaningUnit
wBoard width across the cutin
aCut angle from square°
OOffset along the board edgein
rad(x)the angle x, converted from degrees to radians.

Worked example

Board width across the cut5.5 in
Cut angle from square45 °
Length of the cut face (inches)7.7782
Angle between the cut and the board edge (degrees)45
  1. O=5.5×tan⁡(rad⁡(45))=5.5

Offset along the board edge 5.5 in

Each step uses the unrounded value of the step before it; figures on this page are rounded for display.

Frequently asked questions

How long is a 45° cut on a 2 × 6?

On a 5.5-inch face, the long point is 5.5 inches past the short point and the cut face is 7.7782 inches.

What angle do I cut for a corner?

Two pieces meeting at a 90° corner are each cut at 45°; for any corner, use half the corner angle's supplement, (180° − corner) ÷ 2.

Questions answered

Related calculators