Skip to content
FiftyCalc Free calculators for all 50 states

Bowl Segment Calculator

Test cases replayed : 2 of 2 match · Methodology · No outside source listed

Enter the number of segments in the ring, the ring's outside diameter and the ring width (wall) for woodturning.

Result

Sample figures

Miter angle at each end, from square—°

Segment length, outside edge (inches) —

  • Segment length, inside edge (inches)—
  • Strip length for one ring, no saw kerf (inches)—

The unit choice applies to the fields you fill in. Results stay in the units written with them.

Estimate for planning only, not tax, legal, financial or medical advice. This calculator uses the method explained on this page.

Bowl Segment Calculator

Units: switches the fields between the two unit systems.

Segments per ring: enter 3 or more. Prefilled example: 12.

Outside diameter of the ring, across flats, in in: enter 0 or more. Prefilled example: 10.

Ring width, outside to inside, in in: enter 0 or more. Prefilled example: 1.

How to use this calculator

Fill in the fields in this order; each step takes you to its field.

  1. Units: switches the fields between the two unit systems.
  2. Segments per ring: enter 3 or more.
  3. Outside diameter of the ring, across flats, in in: enter 0 or more.
  4. Ring width, outside to inside, in in: enter 0 or more.
  5. Read the result: Miter angle at each end, from square; the panel also shows Segment length, outside edge (inches), Segment length, inside edge (inches) and Strip length for one ring, no saw kerf (inches).

How this calculator works

A ring of n segments is a regular polygon. Each segment's two ends are cut at 180° ÷ n from square, so two neighbors close an angle of 360° ÷ n.

Outside length = 2 × R × tan(180° ÷ n), with R half the outside diameter across flats; inside length = 2 × (R − ring width) × tan(180° ÷ n). Add the saw kerf per cut to the strip length.

The formula

  1. M=180n
Symbols used in the formula
SymbolMeaningUnit
nSegments per ring
MMiter angle at each end, from square°

Worked example

Segments per ring12
Outside diameter of the ring, across flats10 in
Ring width, outside to inside1 in
Segment length, outside edge (inches)2.6795
Segment length, inside edge (inches)2.1436
Strip length for one ring, no saw kerf (inches)32.15
  1. M=18012=15

Miter angle at each end, from square 15 °

Each step uses the unrounded value of the step before it; figures on this page are rounded for display.

Frequently asked questions

What miter angle for a 12-segment ring?

180 ÷ 12 = 15 degrees on each end.

How long is each segment of a 10-inch, 12-segment ring?

10 × tan(15°) = 2.6795 inches on the outside edge.

Related calculators