Skip to content
FiftyCalc Free calculators for all 50 states

Ramp Slope Calculator

Test cases replayed : 3 of 3 match · Methodology · Sources

Enter the total rise (the height to climb) in inches and the horizontal run in feet.

Result

Sample figures

Slope ratio, 1 : x—

Grade —

  • Angle (degrees)—
  • ADA running slope—
  • Shortest run at 1:12 (feet)—
  • Ramp runs needed (30 inches of rise each at most)—

The unit choice applies to the fields you fill in. Results stay in the units written with them.

Estimate for planning only, not tax, legal, financial or medical advice. Check important figures with the official source listed on this page.

Ramp Slope Calculator

Units: switches the fields between the two unit systems.

Total rise, in in: enter 0.01 or more. Prefilled example: 24.

Horizontal run, in ft: enter 0.01 or more. Prefilled example: 30.

How to use this calculator

Fill in the fields in this order; each step takes you to its field.

  1. Units: switches the fields between the two unit systems.
  2. Total rise, in in: enter 0.01 or more.
  3. Horizontal run, in ft: enter 0.01 or more.
  4. Read the result: Slope ratio, 1 : x; the panel also shows Grade, Angle (degrees), ADA running slope, Shortest run at 1:12 (feet) and Ramp runs needed (30 inches of rise each at most).

Sources

How this calculator works

Slope = rise ÷ run, with both in inches. A 1:12 slope rises 1 inch per 12 inches of run, so the shortest run in feet equals the rise in inches.

2010 ADA Standards, read on 2026-10-27 on the U.S. Access Board (https://www.access-board.gov/ada/): 405.2 "Ramp runs shall have a running slope not steeper than 1:12" (existing sites may use steeper slopes under Table 405.2); 405.6 "The rise for any ramp run shall be 30 inches (760 mm) maximum", with a level landing between runs.

Landings, width, handrails and edge protection have their own rules in section 405; local codes may add more.

The formula

  1. Ra=run×12r
Symbols used in the formula
SymbolMeaningUnit
rTotal risein
runHorizontal runft
RaSlope ratio, 1 : x

Worked example

Total rise24 in
Horizontal run30 ft
Grade6.67%
Angle (degrees)3.81
ADA running slopeNot steeper than 1:12 (ADA 405.2)
Shortest run at 1:12 (feet)24.00
Ramp runs needed (30 inches of rise each at most)1
  1. Ra=30×1224=15

Slope ratio, 1 : x 15.00

Each step uses the unrounded value of the step before it; figures on this page are rounded for display.

Frequently asked questions

How long must a ramp be to climb 24 inches?

At 1:12, 24 × 12 = 288 inches, or 24 feet of run, not counting landings.

What percent grade is 1:12?

1 ÷ 12 = 8.33%, about 4.76°.

Questions answered

Related calculators