Skip to content
FiftyCalc Free calculators for all 50 states

Stockpile Volume Calculator

Test cases replayed : 2 of 2 match · Methodology · No outside source listed

Measure the base diameter and the height of a cone-shaped pile. You get its volume in cubic feet and cubic yards, its approximate weight, and the slope of its sides.

Result

Sample figures

Volume—cu yd

Volume (cubic feet) —

  • Approximate weight (tons)—
  • Side slope from horizontal (degrees)—

Estimate for planning only, not tax, legal, financial or medical advice. This calculator uses the method explained on this page.

Stockpile Volume Calculator

Base diameter of the pile, in ft: enter 0 or more. Prefilled example: 20.

Height of the pile, in ft: enter 0 or more. Prefilled example: 8.

Density (tons per cubic yard; example value, replace it with your supplier's figure): enter a number from 0.5 to 3. Prefilled example: 1.4.

How to use this calculator

Fill in the fields in this order; each step takes you to its field.

  1. Base diameter of the pile, in ft: enter 0 or more.
  2. Height of the pile, in ft: enter 0 or more.
  3. Density (tons per cubic yard; example value, replace it with your supplier's figure): enter a number from 0.5 to 3.
  4. Read the result: Volume; the panel also shows Volume (cubic feet), Approximate weight (tons) and Side slope from horizontal (degrees).

How this calculator works

A pile dumped from one point forms a right circular cone. Volume = π × r² × h ÷ 3 = π × D² × h ÷ 12, with D the base diameter and h the height, both in feet. Cubic yards = cubic feet ÷ 27.

Tons = cubic yards × density. Ask your supplier for the weight per cubic yard of the material in the pile.

Side slope = arctan(2h ÷ D). For a freely dumped pile it is close to the material's angle of repose.

Measure the diameter across the middle of the base, in two directions at right angles, and take the average. A long ridge-shaped (windrow) pile is not a cone and is not covered here.

The formula

  1. C=π×d2×h12
  2. Y=C27
Symbols used in the formula
SymbolMeaningUnit
dBase diameter of the pileft
hHeight of the pileft
CVolumecubic feet
YVolumecu yd

Worked example

Base diameter of the pile20 ft
Height of the pile8 ft
Density (tons per cubic yard; example value, replace it with your supplier's figure)1.4
Volume (cubic feet)837.76
Approximate weight (tons)43.44
Side slope from horizontal (degrees)38.7
  1. C=3.14159×202×812=837.758
  2. Y=837.75827=31.0281

Volume 31.03 cu yd

Each step uses the unrounded value of the step before it; figures on this page are rounded for display.

Frequently asked questions

How many cubic yards are in a pile 20 feet across and 8 feet high?

π × 20² × 8 ÷ 12 ≈ 837.76 cubic feet, about 31.03 cubic yards, or about 43.4 tons at 1.4 tons per cubic yard.

How do I measure the height of a large pile?

Measure the slope length from the edge of the base to the top, s, then h = √(s² − (D ÷ 2)²).

Why does my scale ticket differ from the estimate?

Density changes with moisture and compaction, and real piles are rarely perfect cones. Use the supplier's weight per cubic yard and treat the result as an estimate.

Questions answered

Related calculators