Skip to content
FiftyCalc Free calculators for all 50 states

Low Pass Filter Calculator

Test cases replayed : 2 of 2 match · Methodology · No outside source listed

Find where a first-order RC low-pass filter starts cutting high frequencies, and how much it attenuates a given frequency.

Result

Sample figures

Cutoff frequency—Hz

Time constant RC (ms) —

  • Gain at the signal frequency (dB)—
  • Phase shift at the signal frequency (degrees)—

Estimate for planning only, not tax, legal, financial or medical advice. This calculator uses the method explained on this page.

Low Pass Filter Calculator

Resistance: enter 0 or more. Prefilled example: 1.

Resistance unit

Resistance unit: choose Ohms (Ω), Kilohms (kΩ) or Megohms (MΩ). Prefilled example: Kilohms (kΩ).

Capacitance: enter 0 or more. Prefilled example: 100.

Capacitance unit

Capacitance unit: choose Microfarads (µF), Nanofarads (nF) or Picofarads (pF). Prefilled example: Nanofarads (nF).

Signal frequency to check, in Hz: enter 0 or more. Prefilled example: 5,000.

How to use this calculator

Fill in the fields in this order; each step takes you to its field.

  1. Resistance: enter 0 or more.
  2. Resistance unit: choose Ohms (Ω), Kilohms (kΩ) or Megohms (MΩ).
  3. Capacitance: enter 0 or more.
  4. Capacitance unit: choose Microfarads (µF), Nanofarads (nF) or Picofarads (pF).
  5. Signal frequency to check, in Hz: enter 0 or more.
  6. Read the result: Cutoff frequency; the panel also shows Time constant RC (ms), Gain at the signal frequency (dB) and Phase shift at the signal frequency (degrees).

How this calculator works

First-order RC low-pass filter: cutoff (−3 dB) frequency f_c = 1 ÷ (2π × R × C) and time constant τ = R × C.

Gain |H| = 1 ÷ √(1 + (f ÷ f_c)²), shown in decibels as −10 × log₁₀(1 + (f/f_c)²), and phase φ = −arctan(f ÷ f_c). Above the cutoff the output falls 20 dB per decade. The source impedance should be low and the load high compared with R.

The formula

  1. Fc=12×π×r×ru×c×cu
Symbols used in the formula
SymbolMeaningUnit
rResistance
ruResistance unit
cCapacitance
cuCapacitance unit
FcCutoff frequencyHz

Worked example

Resistance1
Resistance unitKilohms (kΩ)
Capacitance100
Capacitance unitNanofarads (nF)
Signal frequency to check5,000 Hz
Time constant RC (ms)0.1
Gain at the signal frequency (dB)-10.3621
Phase shift at the signal frequency (degrees)-72.3432
  1. Fc=12×3.14159×1×1,000×100×0.000000001=1,591.55

Cutoff frequency 1,591.5494 Hz

Each step uses the unrounded value of the step before it; figures on this page are rounded for display.

Frequently asked questions

What is the cutoff of 1 kΩ with 100 nF?

About 1,591.5 Hz.

How much is a signal attenuated at the cutoff frequency?

By 3.01 dB (to about 70.7% of its amplitude), with a 45° phase lag.

Related calculators