Skip to content
FiftyCalc Free calculators for all 50 states

Spindle Speed Calculator

Test cases replayed : 2 of 2 match · Methodology · No outside source listed

Enter the cutting speed recommended for your tool and material, the tool (or workpiece) diameter, then the flutes and chip load for the feed.

Result

Sample figures

Spindle speed—RPM

Feed rate (inches per minute) —

  • Cutting speed (meters per minute)—

Estimate for planning only, not tax, legal, financial or medical advice. This calculator uses the method explained on this page.

Spindle Speed Calculator

Cutting speed (surface feet per minute): enter 0 or more. Prefilled example: 300.

Tool or workpiece diameter, in in: enter 0.001 or more. Prefilled example: 0.5.

Number of flutes or teeth: enter 1 or more. Prefilled example: 4.

Chip load (inches per tooth): enter 0 or more. Prefilled example: 0.002.

How to use this calculator

Fill in the fields in this order; each step takes you to its field.

  1. Cutting speed (surface feet per minute): enter 0 or more.
  2. Tool or workpiece diameter, in in: enter 0.001 or more.
  3. Number of flutes or teeth: enter 1 or more.
  4. Chip load (inches per tooth): enter 0 or more.
  5. Read the result: Spindle speed; the panel also shows Feed rate (inches per minute) and Cutting speed (meters per minute).

How this calculator works

RPM = 12 × SFM ÷ (π × D): the surface speed in feet per minute is turned into inches (× 12) and divided by the circumference of the tool, π × D. Feed rate = RPM × number of teeth × chip load.

Cutting speed and chip load come from the tool maker's data for your material. 1 foot = 0.3048 m (NIST Handbook 44 Appendix C, 2026, read on 2026-10-27).

The formula

  1. Rpm=12×sfmπ×d
Symbols used in the formula
SymbolMeaningUnit
sfmCutting speed (surface feet per minute)
dTool or workpiece diameterin
RpmSpindle speedRPM

Worked example

Cutting speed (surface feet per minute)300
Tool or workpiece diameter0.5 in
Number of flutes or teeth4
Chip load (inches per tooth)0.002
Feed rate (inches per minute)18.33
Cutting speed (meters per minute)91.4
  1. Rpm=12×3003.14159×0.5=2,291.83

Spindle speed 2,292 RPM

Each step uses the unrounded value of the step before it; figures on this page are rounded for display.

Frequently asked questions

What RPM for a 1/2-inch end mill at 300 SFM?

12 × 300 ÷ (π × 0.5) ≈ 2,292 RPM; with 4 flutes at 0.002 in, the feed is about 18.33 in/min.

Why does a smaller tool spin faster?

Its circumference is smaller, so it needs more turns per minute to keep the same surface speed.

Related calculators